MKS BASEV1 2 3D Printer Controller Board for RAMPS1 4 Arduino 2560 Remix Board | eBayĪnd, in addition, it will require two of these? So you are using something similar to this one?
yes the 40w is not powerful enough, but it'll get the job done eventually.Īll told I have maybe $100.00 in my upgrade. I had a engraving job running on a 85mm x 150mm granite sewing weight, it's a 8 hour job. Look for my post earlier this week on software, I uploaded my modded turnkey inkscape extension. I do cuts of 1/4" plywood, engrave granite, so vector and raster using this setup. I use an air assist nozzle with a select comfort bed air pump I modded.
The MKS board is an arduino and ramps 1.4 together with some extra channels. And I use the turnkey recommended marlin firmware for the arduino. I use inkscape 0.91 for generating my code using turnkeylaser extension. I yanked my moshidraw board a week after I started using it.
0 kommentar(er)
